8. Align and insert the contacts on the track head assembly
(H) with the contact channel on the rail (G).
IMPORTANT: Make sure the "L" line contact inserts into
the upper channel.
The "N" line contact inserts into the lower channel
and the ground tab rests on the copper ground on top
of the track rail.
9. Close the connectors on the track head assembly
(H) and re-attach decorative collar (D) and
decorative end cap (E), locking the connector closed.
CAUTION: Never slide the track head assembly (H)
along the track rail (G), as it will scratch the finish.
10. The track light can be configured in several
different ways. However, do not make any sharp
bends in the track and do not bend the track more
than 90 within a 12-in. portion.
°
8
Ground
Groove
Identation
Track
(Front)
Track
(Back)
9
G
10
6
Ground Tab
L
N
G
H
E
D
H