SCS XO 006 C Manual De Instalacion Y Uso página 7

E- To add a new badge (BADGES function)
1) Enter programming mode.
2) Enter 6 2 2 .
3) Enter the badge's code ( 0 0 1 for the first up to
4) Move the badge in front of the keypad.
5) Press # (to confirm).
6) If you want to continue the programming, move on directly to
another step. If you want to stop the programming, press 0 .
F- To remove a badge and its user code
1) Enter programming mode.
2) Press 3 .
3) Enter the code of the badge to remove.
(Example: 0 0 1 ).
G- To remove all the codes
1) Enter programming mode.
2) Press 4 4 4 4 (only the programming code is not deleted).
3) If you want to continue the programming, move on directly to
another step. If you want to stop the programming, press 0 .
=> PROGRAMMING THE TYPE OF USING
1) Enter programming mode.
2) To choose :
- Key function: Press 6 2 + # (to confirm).
- Key OR code function: 6 0 + # .
- Key AND code function 6 1 + # .
3) If you want to continue the programming, move on directly to
another step. If you want to stop the programming, press 0 .
=> PROGRAMMING THE OPENING TIME
To program the opening time of the door
1) Enter programming mode.
2) Press 5 plus the time required in seconds.
(Example 5 2 0 for 20 seconds of opening time).
3) If you want to continue the programming, move on directly to
another step. If you want to stop the programming, press 0 .
=> ALARM PROGRAMMING
To enable the full alarm:
1) Enter programming mode
2) Press 8 1 . No programmed code can be used.
Press 8 0 to disable the alarm
3) If you want to continue the programming, move on directly to
another step. If you want to stop the programming, press 0 .
=> REMINDER : If you want to stop the programming, press 0 .
=> DOOR OPENING: Enter the code followed by # to confirm.
The door will open.
=> LOST PROGRAMMING CODE: If you forget your code, you
must switch off the current, open up the keypad and press «REST»
(function within the keypad). While pressing and holding REST,
power up the keypad and wait for 3 seconds.
Close the keypad and you can then begin the programming
operation again.
=> FALSE CODE: If you enter 8 successive false codes, the keypad
will lock automatically, and the alarm will be triggered.
The alarm will sound for 90 seconds.
5)WIRING DIAGRAM
Follow the instructions opposite to install the keypad.
1
3
5
7
9
Power supply
Alimentation
+
RED
Rouge
BLACK
Noir
YELLOW
(NC Contact)
Jaune
2 (Contact NC)
BLUE
(NO contact)
Bleu
ou (Contact NO)
4
WHITE
Blanc
6
GREEN
Vert
8
ORANGE
Orange
0 GREY
Gris
GREY
#
Gris
Chime (dry
Carillon
contact) (contact sec)
-
+
-
Electric lock (12 V)
To black
Vers NOIR
Automatisme (contact sec)
Automated system (dry contact)
Door magnetic
Interrupteur
Additional Alarme
switch
magnétique
additionnelle
alarm
de la porte
ENGLISH
Serrure
électrique (12V)
Exit button
Bouton
de sortie
5 0 0 )