SNOWJOE SUNJOE SPX4600 Manual Del Operador página 10

Ocultar thumbs Ver también para SUNJOE SPX4600:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. 14
Power light
indicator
GFCI
NOTE: The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until
the power light indicator on the GFCI illuminates when
plugged in.
5. Turn the water supply tap on completely.
6. Make sure the safety lock is down and in its original
position (Fig. 15), then press the trigger for a few seconds
until water flow is steady. This will allow air to escape and
discharge any residual pressure in the hose.
Fig. 15
7. Turn the ON/OFF switch to the ON/I position to start the
pressure washer (Fig. 16).
Reset
Using Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
Safety lock
The nozzle patterns are 40˚ (for gentle cleaning), 25˚ (for
all-purpose cleaning), 15˚ (for tough jobs), 0˚ (for spot cleaning
or hard-to-reach areas) and the soap nozzle (for detergent
Slot
application).
m
safety lock on the trigger handle.
m
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with five (5) Quick-
Trigger
Connect nozzles that easily snap onto the Quick-Connect
collar of the spray wand.
To connect a nozzle to the spray wand:
10
Fig. 16
ON/OFF
switch
8. When re-starting the motor, always keep the
trigger pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
CAUTION!
NEVER change nozzles without locking the
WARNING!
High-pressure jets can be dangerous if
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing
up on the safety lock until it clicks into the slot (Fig. 17).

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido