Grounding Instructions - NSS Aero Plus Instrucciones Originales

IMPORTANT SAFETY INSTRUCTIONS
WARNING:
can result in a risk of electric shock. Check with a qualified electrician or
service person if you are in doubt as to whether the outlet is properly
grounded. Do not modify the plug provided with the machine. If outlet is
not suitable for safe use; have a proper outlet installed by a qualified
electrician.

GROUNDING INSTRUCTIONS

This machine shall be grounded while in use to protect the operator from electric shock. The machine is
provided with a three-conductor cord and a three-contact grounding type attachment plug. The plug must be
plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes
and ordinances. The green conductor in the cord is the ground wire. Never connect this wire to other than
the grounding pin of the attachment plug.
Check nameplate on the machine to be sure voltage and cycle stated is the same as the electrical outlet.
Do not attempt to plug a 120-volt machine into a 240-volt outlet or a 240-volt machine into a 120-volt outlet.
If the machine is provided with an attachment plug as shown in Figure A. below, it is intended for use on a
nominal 120-volt circuit. If a properly grounded receptacle as shown in Figure A. is not available, an adapter
may be installed as shown in Figure B. if the outlet box that houses the receptacle is grounded. Be sure to
fasten the grounding tab (the green colored rigid ear, lug or the like extending from the adapter) with a metal
faceplate screw.
If the machine is provided with an attachment plug as shown in Figure C., it is intended for use on a nominal
240-volt circuit. Changes to the attachment plug or use of adaptors to other plug types must be done in
accordance with local regulations.
NOTE: In Canada, the use of a temporary adaptor may not be permitted by Canadian electrical code.
ALL REPAIR SERVICE MUST BE PERFORMED BY AN NSS AUTHORIZED DISTRIBUTOR /
SERVICE STATION USING ONLY NSS ORIGINAL EQUIPMENT PARTS.
GROUNDING OF ELECTRICAL EQUIPMENT
Improper connection of the equipment–grounding conductor
SAVE THESE INSTRUCTIONS