Setting The Temperature; Setting The Timer - King of Fans MAXI-HEAT CH940 Manual De Usario

plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician. Do not
attempt to defeat this safety feature.
2. TURNING THE HEATER ON:
To turn the heater ON, press the
MODE button. The heat setting will
be set to AUTO automatically.
Press the MODE button again to
set to HIGH, press a third time to
set to LOW and a fourth time to set
the FAN only.
3. TURNING THE HEATER OFF: To
turn the heater OFF, press the
MODE button and hold for about 3
seconds.

4. SETTING THE TEMPERATURE

Under AUTO mode:
To set the desired temperature:
Press the "+" button once until the
LCD temperature scale starts
flashing.
Press the "+" again to increase the
temperature or the "–" button to
decrease the temperature.
The desired temperature will set and
execute after the LCD stops flashing.
This is your ideal setting. The heater
will start automatically when the room
temperature drops below this set
point and will turn off when the set
point is reached.
The default temperature setting is
preset from the factory at 71 degrees
Fahrenheit.
NOTE: THE AUTO MODE WILL
NOT OPERATE IN THE FAN ONLY
SETTING.

5. SETTING THE TIMER

Under AUTO mode:
To set the Timer:
1. Press the TIMER button until the
Set Time starts flashing. The
default value is 3 hours.
2. Press the "+" button to increase the
set time or the "–" button to
decrease the set time.
The Timer can be set from 1 hour to
12 hours. The Timer will set and
execute after the LCD display stops
flashing. The heater will shut OFF
automatically when the set time is
reached.
3. To turn the Timer OFF, follow step 1
and press the "–" button to set the
time to 0. The Timer feature will
turn off when the LCD stops
flashing.
NOTE: WHENEVER YOU CHANGE
THE TEMPERATURE (+/-) THE
AUTO MODE WILL ACTIVATE.
Oscillating Base
To operate the oscillating base
featured on this heater, press the
"Osc." button located on the control
panel of the heater.