Fcc Compliance; Fcc Statement - Uline H-9384 Guia De Inicio Rapido

FCC COMPLIANCE

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.

FCC STATEMENT

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.
CAUTION! This equipment generates, uses and
can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
NOTE: There is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the space between the equipment and receiver.
• Connect the equipment into an outlet on a circuit
different from the circuit the receiver is connected to.
• Consult the dealer or an experienced radio/TV
technician for help.
CANADA, INDUSTRY CANADA (IC) NOTICES
Class B digital circuitry of this device complies with
Canadian ICES-003. This device complies with Industry
Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must
accept any interference, including interference that
may cause undesired operation of the device.
Under Industry Canada regulations, the radio
transmitter(s) in this device may only operate using
an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
PAGE 2 OF 15
SAFETY CONTINUED
BATTERY SAFETY
Figure 1
WARNING! Indicates a potentially hazardous
situation or an unintended use which, if not
avoided, will result in death or serious injury.
CAUTION! Indicates a potentially hazardous
situation or an unintended use which, if not
avoided, may result in minor injury and/
or appreciable material, financial and
environmental damage.
Important paragraphs that must be adhered to in
practice, as they enable the product to be used
in a technically correct and efficient manner.
WARNING! Batteries can explode or leak and
can cause injury or fire. To reduce this risk:
• ALWAYS follow all instructions and warnings on
the battery label and package.
• DO NOT short any battery terminals.
• DO NOT charge alkaline batteries.
• DO NOT mix old and new batteries. Replace
all of them at the same time with new
batteries of the same brand and type.
• DO NOT mix battery chemistries.
• DO NOT dispose of batteries in fire.
• ALWAYS keep batteries out of reach of children.
• ALWAYS remove batteries if the device will not
be used for several months.
NOTE: Ensure that the correct batteries as
recommended are used.
NOTE: Ensure the batteries are inserted in the
correct manner, with the correct polarity.
(See Figure 1)
1
2
3
0221 IH-9384