Kenmore 407.53571 Manual De Uso página 12

NOTE- Make sure the drain hose is lower than the horizontal plane of the drain on
the dehumidifier as seen in the illustration below. Drain hose should be as short as
possible and all kinks in the drain hose should be eliminated for proper pump opera-
tion.
3ft. Dehumidifier Drain Hose
i
i
i
!
|
(FIG, t7)
NOTE- If you need to cut the dehumidifier drain hose, only cut on the fiat end of the
hose. Do not cut the angled end as it is designed for insertion into the pump.
4
X
CUT DO NOT CUT
J
1. Remove flat end of the hose by squeezing the large clamp and pulling it to-
ward you.
2. Remove hose from drainage joint and cut hose to appropriate length.
3. Once cut is completed, refer to installing the Drain Hose to re-install dehumid-
ifier drain hose.
USING THE DRAIN PUMP
1. Plug into grounded electrical outlet.
2. Place the other end of the pump hose where you would like to empty the wa-
ter (floor drain, water container or through a basement window). The pump
will automatically start and begin pumping the water that drains into it. Check
hose for kinks or other obstructions.
3. Before and after each use, check hose connections to make sure they are
properly secured.
12