Premium PRN165DX Manual De Uso Y Cuidado página 6

long periods of
Prolonged door opening or door ajar.
time.
Door gasket(s) not sealing properly.
Dirty condenser coil.
Evaporator coil iced over.
Cabinet Thermostat set too warm.
temperature is
too warm. Blocking air flow.
Excessive amount of warm product placed in
cabinet.
Fuse blown or circuit breaker tripped.
Dirty condenser coil.
Prolonged door opening or door ajar.
Evaporator coil iced over.
Cabinet is Loose part(s).
noisy.
Tubing vibration.
Ensure doors are closed when not in
use. Avoid opening doors for long
periods of time.
Ensure gaskets are snapped in
completely. Remove gasket and wash
with soap and water.
Check condition of gasket and replace
if necessary.
Clean the condenser coil.
Unplug unit and allow coil to defrost.
Make sure thermostat is not set too
cold. Ensure that door gasket(s) are
sealing properly.
Set thermostat to lower temperature.
Re-arrange product to allow for proper
air flow. Make sure there are at least
four inches of clearance from
evaporator.
Allow adequate time for product to cool
down.
Replace fuse or reset circuit breaker.
Clean the condenser coil.
Ensure doors are closed when not in
use. Avoid opening doors for long
periods of time.
(see above)
Locate and tighten loose part(s).
Ensure tubing is free from contact with
other tubing or components.
5