Emergency Procedures; Troubleshooting Guide; Warranty Information - BriskHeat XtremeFLEX BSAT Serie Manual De Instrucciones

EMERGENCY PROCEDURES

Read and understand these procedures prior to using this heater.
Disconnect power to the heater in the event of an emergency.
Electric Shock:

Do not touch the injured person while they are still in contact with the electrical current.
 Call your local emergency service if the injured person experiences: severe burns,
confusion, difficulty breathing, heart rhythm problems, cardiac arrest, muscle pain and
contractions, seizures or a loss of consciousness.
Minor Burns:

Hold the burned area under cool running water for 10-15 minutes.

Remove rings or other tight items from burned area.
Major Burns:

Call your local emergency service.

Protect the person from further harm.

Remove rings or other tight items from burned area.

Monitor breathing and perform CPR if necessary.
Fire:

Call your local emergency service.

If it is safe to do so, use a fire extinguisher to fight the fire, otherwise evacuate to a safe
distance and wait for help to arrive.

This heater is built from material that will not support a flame but could ignite nearby
combustible material.

TROUBLESHOOTING GUIDE

Please read this guide prior to contacting BriskHeat
commonly asked questions. If you are unable to identify the problem or need additional
assistance, please contact your local distributor/ representative or the BriskHeat factory at:
1-800-848-7673, 614-294-3376, or bhtsales1@briskheat.com.
PROBLEM SOLUTION(S)
Heater does not turn on. Verify heater is connected to proper voltage.
Verify controller is not in the "off" position.
Circuit breaker or GFCI is Verify circuit breaker is rated for the current requirements marked
tripping. on the heater's label.
Inspect heater for damage (see inspection procedure).
Inspect wiring terminations (qualified person only).
®
© BriskHeat Corporation. All rights reserved.
®
XtremeFLEX BSAT
Silicone Rubber Heating Tape
®
. This guide is designed to answer the most
7

WARRANTY INFORMATION

BriskHeat warrants to the original purchaser of this product for the period of eighteen (18) months
from date of shipment or twelve (12) months from date of installation, whichever comes first.
BriskHeat's obligation and the exclusive remedy under this warranty shall be limited to the repair
or replacement, at BriskHeat's option, of any parts of the product which may prove defective
under prescribed use and service following BriskHeat's examination, is determined by BriskHeat
to be defective. The complete details of the warranty can be found online at www.briskheat.com
or by contacting us at 1-800-848-7673 (toll free, U.S. / Canada) or 1-614-294-3376 (Worldwide).
Corporate Headquarters:
4800 Hilton Corporate Dr.
Columbus, OH 43232, U.S.A.
Toll Free: 800-848-7673
Phone: 614-294-3376
Fax: 614-294-3807
Email: bhtsales1@briskheat.com
®
© BriskHeat Corporation. All rights reserved.
®
XtremeFLEX BSAT
Silicone Rubber Heating Tape
Europe:
P.O. Box 420124
44275 Dortmund, Germany
8