Operation; Operation Panel - Selecta PERCOM N-M II Manual De Instrucciones

INSTRUCTION MANUAL
J
.P. SELECTA s.a.u.
CODE 80357 REV A

7. Operation

7.1 Operation Panel

1.
2.
3.
4.
5.
6.
7.
8.
• Left / right reversal Key
Drive control running direction. By pressing left / right reversal key once, the drive
running direction will change once. When the drive rotates left, left rotation display
lamp lights; when the drive is rotating right, right rotation display lamp lights.
• Start/ Stop Key
To run and stop the drive. By pressing the key start / stop once, the drive running
state will change once. When the drive is running, the start / stop display lamp
lights; also, when the drive stops working, the start / stop display lamp turns off.
If you press the key for a long time, you could set the RS485 address. If you
press the key for more than 5 secs, a number will blink, press the acceleration /
deceleration key to set the required address, and then press the start / stop key
to save the address.
Acceleration / deceleration Key
•
Use when increasing or decreasing the motor running speed. By pressing the
acceleration / deceleration key once, the motor speed will increase or decrease
0.1r/min. If pressing the key in a continuous way, the drive rotating speed will
quickly increase or decrease for shortening the adjustment time.
• Full / empty Key
Under the internal control mode, if pressing the full speed key, the pump will run
at full speed. The, "Full" state will be shown, and it will finish emptying quicker,
during the filling or the washing operation; if pressing the full speed button again,
the pump will return to the normal status. Under the full mode, the start / stop
key will also stop the drive from running.
• Timer Key
The timer key is used with the internal control mode. When the drive stops
working, hold this key for more than 3 secs. to enter the motor in a working
time interface, and then the LED display will blink showing the currently setting
working time. Press the acceleration / deceleration buttons to set the working
time (press the acceleration / deceleration buttons in a continuous way, and the
setting working time will increase or decrease quickly). The range will go from
0.5s to 999s. After the setting, press again the Timer key to return to the speed
display interface. Then, click the timer key and the driver will work at the current
speed. When the time set arrives, the pump will automatically stop working. (If
you press the start / stop key when the pump is working, it will stop. If you set
again, the driver will recycle again).
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
OCT/2018 (It can be modified without notice)
2
1
8
LED data display
Display lamp of external mode / operation mode
Left / right reversal key
Start / stop key
Acceleration / deceleration keys
Full / empty key
Timer key
External control mode key
3
4
5
6
7
Tel 34 937 700 877 Fax 34 937 702 362
Page: 12