Publicidad
Idiomas disponibles
Idiomas disponibles
11. Install fan blade assembly onto motor
shaft by tightening the set screw on blade
assembly to the sunken space on motor
shaft. Make sure set screw is tightly
secured by a Philips-head screw driver
(not provided).
12. Assembly front guard to rear guard by fixing both
guards together with clips on the rim of front
guard.
13. Adjust extension pipe to your desired height
and secure it by tightening the height
adjustment knob. Pass the supply cord
through cord warp clip.
OPERATING INSTRUCTIONS:
1.
Set fan on a dry, stable, flat surface.
2.
Connect power plug to any standard 120-volt AC outlet. Caution: Make sure
the Speed Control is in the off position.
3.
Pass the Supply Cord through Cord Warp Clip.
4.
Pull the chain on the motor assembly to set to the desired setting –The pull
chain controls the fan speed as follows: 1 pull-Low, 2 pulls-Medium, 3 pulls-
High and 4 pulls-Off.
5.
To change the tilting angle of the Fan Head, Loosen the Tilt Adjustment Knob
on the fan head joint,, tilt the Fan Head to the desired angle and tighten 3
prong knob.
Note :It is normal for the motor to feel warm to touch during operation. The motor is
thermally protected and will automatically shut off when it overheats for any reason.
If this happens immediately disconnect the fan from the power outlet.
Publicidad
