Dri-Eaz Dri-Pod Manual Para El Usuario

Dri-Pod™ Direct Flow Carpet Dryer
The Dri-Pod is a high velocity airmover that creates an aggressive 360°airflow
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
Read and understand this manual before operating.
WARNING! To reduce the risk of fire or electric shock, do not
use this fan with any solid-state speed control device.
WARNING! Unit must be grounded. Do not use with an
extension cord. Connect only to an outlet provided with a ground
fault interrupting device.
WARNING! Never operate a unit with a damaged power cord, as
this may lead to electrical or fire hazards. If power cord is
damaged, it must be replaced by a cord of the same type and
amperage rating.
WARNING! Do not touch grills when unit is operating.
NOTICE: Keep motor dry. For indoor use only.
NOTICE: Unplug when not in use or when moving unit.
NOTICE: Do not allow children to play with or around the unit.
Be sure the unit is inaccessible to children when not attended.
NOTICE: Always operate the unit on a stable, level surface so it
cannot fall and cause injury.
OPERATING INSTRUCTIONS
1. Unwrap the cord and plug the unit into a standard 115V
outlet. CAUTION: Be sure switch is in the off position before
connecting unit to power outlet.
2. Position the Dri-Pod in the center of an area to be dried.
Switch on. The Dri-Pod can dry an area approximately
10 × 10 ft. (3 × 3 m).
3. When surface is dry to the touch, switch unit off and
reposition the unit in the next section to be dried.
4. When finished, unplug the unit and re-wrap the cord in the
cord wrap.
Transporting and Storing
1. Always use the handle to load or carry the unit. Units may
be stacked for transport and storage.
2. When transporting in a vehicle, secure the unit carefully to
prevent sliding and damage to the unit and/or injury to
vehicle occupants.
07-01759B 2012-04 Warranty 07-01760
Owner's Manual
Patent Pending
across floor surfaces to accelerate drying.
PARTS IDENTIFICATION
FOR SERVICE CALL YOUR LOCAL DISTRIBUTOR or the Dri-Eaz
Service Department at 800-932-3030
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA USA 98233
Fax: 360
www.dri-eaz.com
SPECIFICATIONS
Model
Weight
Dimensions
Amp draw
Control
Power
Cord length
Fan
Construction
Safety
Specifications are subject to change without notice. Some values
may be approximate.
1
Handle
Cord wrap
7950 Phone: 360
757
- -
F451
10.6 lbs. | 4.8 kg
15.2 × 15.2 × 8.9 in.
(D × W × H) 38.5 × 38.5 × 22.5 cm
1.1 amps
On/off switch
235W/115V
10 ft. | 3 m
5 blades
Injection molded housing, wire grill
ETL approved to UL and CSA standards
On/off switch
757 7776
- -
Dri-Eaz Products, Inc.