Polk PRC100BC Guía De Instalación Y Funcionamiento

Introduction
Thank you for choosing a Polk product. The PRC100BC marine remote control allows convenient operation of
compatible Polk marine source units including power on/off, volume adjustment, mode selection and basic
functions of available sources such as AM/FM tuner, Weather Band, Bluetooth, USB, iPod/iPhone, SiriusXM
satellite radio.
Up to three Polk marine remote controls (PRC100BC and/or PRC200BC) can be connected to a compatible
Polk marine source unit by using a remote control Y-cable (part #: PRCYC1, sold separately). One Y-cable is
required for each additional remote control (e.g.: One Y-cable for two remote controls total. Two Y-cables for
three remote controls total.)
Installation
1. Choose a smooth, flat, sturdy mounting location that has been verified safe and that has a minimum of 2.5"
depth of unobstructed space behind mounting surface for rear of remote control's body. Also verify that
there is enough room for routing connection cable to source unit and access for securing threaded
mounting ring.
Important: Do not choose mounting location were remote control can become submerged.
2. Carefully cut a 2" diameter hole in chosen mounting surface. Mounting template supplied on next page.
3. Route supplied 18' extension table from remote control to source unit making sure the correct sex of plugs
are in the correct direction. Connect extension cable to source unit and remote control.
If longer cable length is needed or additional remote controls are added, up to two additional 18' extension
cables (part #: PRCEC18, sold separately) can be connected for a total of 54'.
Important: Ensure that route between source unit and remote control does not have any sharp, abrasive
edges, excessively tight bends or areas that can pinch extension cable as this can negatively affect
performance and/or cause damage to connected devices.
4. Insert the remote control into the hole from front of mounting surface, align face to desired position and
secure from back of mounting surface by threading supplied mounting ring onto back of remote control until
tight. (Figure A)
Figure A
PRC100BC Marine Remote Control
Installation and Operation Guide
www.asaelectronics.com
©2013