Tripp-Lite SRWB6210STR Guia De Instalacion página 2

Preparation and Fabrication
Wire Tray Models and Dimensions
Before proceeding with fabrication, first confirm your wire tray model and dimensions.
Model
SRWB6210STR
SRWB12210STR
SRWB6410STR
SRWB12410STR
SRWB18410STR
How to Cut Wire Trays
Notes:
• Always use side-action bolt cutters.
• Angle all cuts away from the new end.
• Cut each wire with one clean cut whenever possible.
• Remove any sharp edges to eliminate possible damage to cables.
Cut the bottom wires first with the underside of the tray
facing up in the order as shown:
1
2
3
Repeat as needed. For various wire cutting patterns and installation diagrams, refer to the documentation included with the
connectors and connector kits (sold separately).
19-07-393-9339DD.indb 2
Sectional View
4
5
6
1111 W. 35th Street, Chicago, IL 60609 USA • tripplite.com/support
Height
2 in. (50 mm) 6 in. (150 mm)
2 in. (50 mm) 12 in. (300 mm)
4 in. (100 mm) 6 in. (150 mm)
4 in. (100 mm) 12 in. (300 mm)
4 in. (100 mm) 18 in. (450 mm)
To cut the side wires, flip the wire tray over and cut in the
order shown, starting from the top:
1
4
2
3
2
Width Depth
10 ft. (3000 mm)
10 ft. (3000 mm)
10 ft. (3000 mm)
10 ft. (3000 mm)
10 ft. (3000 mm)
1
4
2
3
19-07-393 93-39DD_RevA
10/18/2019 11:30:29 AM