BioLite SolarHome 620 Guia De Incio Rapido página 8

CHARGING IN & POWER USAGE
Your system's power supply is directly affected by the strength of the sun which will vary by weather, season, and time
of day. You can see Current Sun Strength (Screen 3) on your Control Box Display.
Sun
View your Battery Level (Screen 2) on your Control Box
Display. It will take 4-6 hours to fully charge your system,
depending on sun strength and if lights are in use.
Power from the Solar Panel is used to run your lights and the
radio. You can also use this power to charge cell phones and
other small electronics. Use the the USB Port on the right side
of the Control Box to connect your device. If control box is in
sleep, press left or right arrow to wake up before charging.
ONE FULL DAY'S CHARGE WILL RUN:
hours of light with
4 lights on LOW 4 lights on MEDIUM
14 HOURS
13
14 Hours Light
4-6 hours
hours of light with hours of light with
4 lights on HIGH
7 HOURS 4.5 HOURS
CONTROLLING YOUR LIGHTS
The three lights and Control Box have three brightness settings: Low, Medium, and High. Use diagram below to access
desired brightness by pressing Light Switch the correct number of times.
Total run time of your light depends on brightness settings, battery levels, and how many other units or features are
being used at the same time.
Button Presses
Sun
Battery
100%
Battery Light
Hanging Lights
Hanging Lights
The LED on the Security Light Switch will
illuminate when Motion Sensor is active.
Security Light will remain on for 30 seconds
after motion is detected.
1x 2x 3x
Low Medium High
Low Medium High
Low Medium High
30
seconds
4x 5x
Off
Off
Motion Sensor On Off
14