Operating Elements; Before Commissioning; Installing The Pushing Handle; Installing The Brushes - Pallmann 83588 Manual De Instrucciones

1 Lock for fresh water reservoir
2 Switch for brush drive
3 Switch for detergent solution
4 Hose for detergent solution
5 Lint sieve (suction)
6 Lock of pushing handle
7 Release button for the transport wheel
8 Bearing wheel
9 Push handle
10 Strain relief clamp
11 Support of the transport wheel
12 Clip
13 Fresh water tank
14 waste water tank
15 Scraper roller
16 Push-button for vacuum bar change
17 Float
18 Button for brush change
19 Chassis
20 Vacuum bar
21 Brushing rollers
22 Rotating handle for brush contact pres-
sure
23 Pedal to lower vacuum bar
24 Mains plug
25 Carrying handle for waste water tank
26 Fresh water tank cover
10

Operating elements

Before Commissioning

Installing the pushing handle

 Slide the upper slider half onto the low-
er slider half.
ATTENTION
Risk of damage. Do not open cable loops
during assembly.
 Align the borings (2 possible height ad-
justments).
 Connect the slider halves to the lock
screws, discs and star grips.
 Fasten the cable to the slider using
clips.
2
-
EN
Installing the transport wheels
 Insert the transport wheel axles into the
borings on the appliance and lock them.

Installing the Brushes

The brushes must be installed before the
initial operation (see "Maintenance works").