Martha Stewart MTS-CGSH1 Manual Del Operador página 7

2. Gently remove the blade by lifting the end tip of the blade
off of the grass shear + hedge trimmer unit (Fig. 4).
Fig. 4
3. Insert the desired blade into the base of the motor housing
(Fig. 5).
Fig. 5
NOTE: You may need to manually move the blade or gear shaft
in order to align the gear shaft with the gear in the center of the
unit.
4. Align the gear shaft in the middle of the blade with the
gear in the middle of the unit. Align the four (4) lugs so
that the blade lays flat against the housing for a secure
fit (Fig. 6).
Fig. 6
Lugs
Lugs
5. Once the blade is in position, replace the blade cover by
6. Push forward on the blade cover until it slides and clicks
NOTE: If you have any questions, please call the
Snow Joe
1-866-SNOWJOE (1-866-766-9563) for assistance.
Gear shaft
7
aligning the cover with the slots on the base of the motor
housing (Fig. 7).
Fig. 7
into place (Fig. 8). The grass shear + hedge trimmer is now
ready for use.
Fig. 8
+ Sun Joe customer service department at
® ®