Selecta 2000963 Manual De Instrucciones página 20

INSTRUCTION MANUAL CODE 80303 REV B
Fig. 8.9 Information screen
Fig. 8.9.1 Firmware update
Fig. 8.10 Information about connection to the
data network
J
.P. SELECTA s.a.u.
Sep2019
8.9 Information. Firmware update.
The equipment is tested and checked before shipment but there may be impro-
vements in the control operation.
If it is necessary to update the firmware version, press the INFORMATION
option and Fig 8.9 appears.
Press the UPGR key and follow the instructions that appear on the
screen. A screen similar to Fig 8.9.1 will appear.
To obtain the file with the update, it is necessary to know the DEVICE ID code
that appears in screen Fig 8.9. Load this file into a USB memory and insert it
into the front connector.
Attention: during the update process DO NOT turn off the equipment or remove
the USB memory from the connector. The equipment could run out of control.
The update process lasts a few minutes. During the update process the control
is turned off several times, but this is normal.
Press the BACK key to return to the settings menu or the HOME key to return
to the initial screen.
8.10 Information about connection to data network
From the INFORMATION menu you can query communication data to a data
network.
Press the NET button to see this information.
Press the BACK key to return to the settings menu or the HOME key to return
to the initial screen.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España Tel 34 937 700 877 Fax 34 937 702 362
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(It can be modified without notice) Page: 20