Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
*
Select magenta jet soap PrecisionSpray
TM
nozzleto
launch soap to second story siding and windows.
Select black fan soap PrecisionSpray
TM
nozzle for
general cleaning. Greatfor applying soap to
vehicles, boats, driveways, decks, and patios.
FAN SOAP
3.
Pull back on collar, insert new PrecisionSpray
TM
nozzle
and releasecollar. Tug on nozzleto makesure it is securely
in place.
Usage Tips
*
For most effective cleaning, keep PrecisionSpray
TM
nozzle
from 8 to 24 inches (20 to 61 cm) away from cleaning
surface.
*
If you get PrecisionSpray
TM
nozzle too close, especially
using a high pressure nozzle,you may damage surface
being cleaned.
,
DO NOTget closer than 6 inches (15 cm) when cleaning
tires.
2-IN-1 SIPHONSYSTEM
Cleaning and Applying Detergent with
the Project Pro® PerfectMix
TM
Siphon
CAUTIOH
Chemicals can cause bodily injury, and/or property
damage.
NEVER usecausticliquid with pressurewasher.
UseONLYpressure washersafedetergents/soaps. Followall
manufacturers instructions.
To apply undiluteddetergent using
the blue PerfectMix
TM
siphen,
felJow these steps:
1.
Review use of PrecisionSpray
TM
nozzles.
2.
Attach PerfectMix
TM
siphon hose to
pump and PerfectMix
TM
concentrate
bottle.
3.
Make sure fan soap (black) or jet soap
nozzle (magenta)is installed.
NOTE:Detergentcannot be applied with the high pressure
nozzles (Cyan,Orange or Red).
4.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE
You must attach all hoses before you start the engine.
Startingthe enginewithoutall the hosesconnected andwithout
thewaterturnedONwill damage the pump.
Damage to equipment r esultingfrom failureto followthis
instruction will void warranty.
5.
Start engine following instructions How to Start Your
Pressure Washer.
6.
Placethreaded end of detergent siphoning tube into
detergent container. Tighten by hand.
7.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
8.
Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as neededto prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
Cleaning and Applying Detergent with
the Standard Clear Siphon
To apply diluted detergent using the
standard cJearsiphontube,
felJew these steps:
1.
Review use of
PrecisionSpray
TM
nozzles.
2.
Attach clear siphon hose to pump.
3.
Mix detergent solution as required by job.
4.
Placesmall filter end of clear siphoning tube into
container with diluted solution as described above.
NOTICE
Contact with the hot muffler can damage detergent
siphoning tube.
Wheninsertingthe siphoninto a detergent s olutionbottle,
routethe tubeso asto keepit from inadvertently contacting the
hot muffler.
NOTE:Make sure the filter is fully submerged in fluid while
applying solution.
5.
Make sure fan soap (black) or jet soap nozzle (magenta)
is installed.
NOTE:Detergentcannot be applied with the high pressure
nozzles (Cyan,Orange or Red).
6.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
7.
Start engine following instructions How to Start Your
Pressure Washer.
14
Publicidad
Tabla de contenido
