CARE AND MAINTENANCE
The radio portion of your new sound system does not require any maintenance. We recommend you keep this
manual for general reference of the many features found in this unit.
As with any cassette player, the cassette section of this sound system does require a minimum of maintenance to
keep it in good working condition. The following simple care and maintenance suggestions should be followed to
prevent malfunctions of the cassette system.
Cassette Care:
1. Purchase a cassette cleaning kit from your local retail store. Use it! At least every 20 to 30 hours of operation
you must clean the cassette mechanism. A dirty cassette player will have a poor sound.
2. Do not use cassettes that exceed 45 minutes of play on each side.
3. Do not insert a cassette that appears to be broken, twisted or dirty or with loose or torn labels on it.
4. Always keep your cassettes away from direct sunlight or exposure to sub-freezing conditions. If a cassette
is cold, allow it to warm up before use.
5. Do not keep a cassette in the player when not in use.
6. Before inserting a cassette in the player, check that the tape is tightly wound on the reels.
Take up any excess slack using a pencil to turn the drive hub in the cassette (see diagram).
SPECIFICATIONS
Size:
Operating Voltage:
Output Power:
Output Wiring:
Output Impedance:
Tuning Range:
Sensitivity:
Tape Frequency Response:
Tape S/N Ratio:
Wow & Flutter:
7" W x 2" H x 4 1/2" D (178mm x 50mm x 115mm)
12 volts DC, negative ground
7 watts maximum
Common-ground type designed for 2 speaker use.
May also be used with 4 speakers.
Compatible with 4-8 ohm speakers
AM: 540 - 1,710 KHz., FM: 88 - 108 MHz.
AM: 15 uv., FM: 2.5 uv.
50-10,000 Hz.
50 dB
0.25% WRMS
* Specifications are subject to change without notice.
-3-
128-5046A
4 of 28