SteriShoe STSH-002 Manual De Instrucciones página 8

Troubleshooting
There are safety features in the SteriShoe® shoe
sanitizer to prevent a user from being exposed to the
UV light. If the on/off button is blinking, one of the
safety features has likely been activated.
The error chart is listed below. If you have any
questions, please call 1-866-686-7463, ext 2 for technical
assistance.
Error and Remedy
blink pause blink
The ambient light sensor has detected light. Be sure
that the SteriShoe® shoe sanitizer is inside a shoe. If
the shoe is a sandal or open shoe, be sure to place the
SteriShoe® shoe sanitizer and shoe inside the provided
shoe bags. If the error is still present, try pressing
down on the tongue of the shoe when turning the
SteriShoe® shoe sanitizer on or move to a darker room.
blink blink pause blink blink
The SteriShoe® shoe sanitizer is either not in a shoe or
the shoe is too large to compress the safety switch. Try
using the SteriShoe® shoe sanitizer in a smaller shoe or
13
place something, such as a pair of socks, between
the heel of the shoe and the SteriShoe® shoe sanitizer.
If you are using the SteriShoe® shoe sanitizer with
a shoe that does not have heel support, use the
SteriShoe® shoe strap to keep the SteriShoe® sanitizer
compressed.
blink blink blink pause blink
The lamp is either damaged or not screwed in
completely. If you have this error, unplug the power
and switch the lamps between the left and right shoe
sanitizers.
■ If both units now work (the on/off light remains
illuminated), the lamp may have not been screwed
in completely.
■ If the problem remains with the lamp, e.g. the right
shoe sanitizer was not working and after switching
the lamps the left shoe sanitizer is not working, then
the lamp needs to be replaced.
Note: After turning the shoe sanitizer on, it will take
approximately 10 seconds for this error indicator to
occur. This is the time needed to ignite the UVC lamp.
blink blink
14