Littium Berlin Manual Del Usuario Y Garantía página 46

06. Assembling the mudguard. Place the mudguard on its spot and secure the top bracket to the
Allen screw. This bracket must be placed on the front part of the E-Bike´s fork.
You will see that there are two rods connected to the brackets that are close to the front wheel
axle. Once you place the front wheel on its spot, adjust those rods so that the mudguard stays
at about 1 cm away from the wheel. Carefully tighten the small Allen screws that you will find in
the plastic brackets.
07. Connect both jacks to the front light. These are polarity cables, so, if the light does not turn
on when connecting the battery, disconnect it again and reverse the position of the cables.
42
TOP BRACKET