Promaker PRO-H2000 Manual Del Usuario página 13

• Attach the water supply hose to the coupling on the water connection.
• Connect the water supply hose to the water supply.
Bleed the device as follows prior to operation:
• Turn on the appliance "OFF/ON"
• Unlock the lever of the trigger gun.
• Push the lever of the trigger gun, the device will switch on.
• Let the device run (max. 2 minutes) until the water exits the
trigger gun without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
OPERATION
ATTENTION
Dry running of more than 2 minutes leads to damage of the high-
pressure pump. If the appliance does not build up pressure within
2 minutes, switch the appliance off and proceed in accordance with
the instructions in Chapter "Troubleshooting".
13