Worx MAKER X WA7150 Manual Del Usuario página 9

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
ASSEMBLY
1. Insert battery pack into the hub. (See Fig. A)
2. Connect the hub and MakerX series tools. (See Fig. B)
WARNING: Before operation, make sure the speed control button on
the hub is at the"Min" position. (See Fig. C)
OPERATION
1. Confirm the speed control button is set to "Min". Grasp the tool by the grip.
Press the on/off switch to start. (See Fig. D)
2. Adjust the variable speed as needed for the tool and application.
3. Press the on/off switch on the hub to turn off after use.
NOTE: For sake of safety, disconnect from the hub and adjust the speed control
to "Min" position once completing the operation.
EN
4. With a USB port (output: 5 V, 2 A) (only for specific models), your hub can be
9
connected to a LED light, or used to charge small electronics or tools such as
cell phones, cordless screwdrivers, tablets, etc.. (See Fig. E)
MAINTENANCE
There are no repairable parts in your hub.
For adjustment, repair or maintenance, please leave it to the professional. Do
not try to repair the hub yourself.
Your hub does not need to be lubricated or otherwise maintained. Don't clean
the hub with water or chemical cleaning agent, just wipe it with a dry cloth.
Store in a dry environment.
FCC Part 15
Supplier's Declaration of Conformity
Product Description: 20V Hub/HubX
Model Number: WA7150 WA7151
Trade Name: Worx
This device complies with part 15 of the FCC Rules.