Marshalltown Bullet 620-SID Manual Del Usuario página 7

Step 8 - Insert the Handle Extension (H) into the Handle
Assembly (G) by pushing down the button on the Handle
Extension and sliding it in, making sure the button and
holes on the Handle Assembly line up.
Step 10 - Attach Lower Fence (F) to the Table Assembly
(A) using 1/4- 20 x 11/4" FHP Machine Screws (N) and a
Phillips Screwdriver but leave the screws loose. Make sure
the Bolt attached to the Lower Fence is facing upward.
Step 12 - Finish tightening the 1/4- 20 x 11/4" FHP Machine
Screws (N) from Step 10. Repeat steps 9 through 12 for the
Upper (E) and Lower Fence (F) on the other side of the shear.
WS# 2642
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
ASSEMBLY
Step 9 - Attach the Upper Fence (E) to the Shear
Assembly (B) using M6-1.0 x 35mm PHP Machine Screws
(K) and a Phillips Screwdriver.
Step 11 - Insert the Bolt on the Lower Fence (F) through the
sliding hole on the Upper Fence (E). Use 5/16" x 1" washer (V)
and knob (U) to connect the Upper and Lower Fence.
7 of 20