Kripsol KLX Serie Manual Del Usuario página 23

Connection
Output: 12 V
Max 50 W
12 V direct connection
for LED spotlight
(Up to 50 W)
No need to use an
electrical panel
or independent
transformer.
Page 9 of 12
8.1 Lighting
8.4 LED spotlights: If your pool has LED
spotlights, use this menu to configure the
lighting.
9. PH PUMP RELAY
Connection
110 – 230 V
Max. 1.15 A
USE ONLY GENUINE REPLACEMENT PARTS
8. LIGHTING
8.1
8.2 Manual ON / OFF mode.
8.4
8.5 Colour selection: Using this menu
you can change the colour of the lights in
your pool. The Next Program option will
manually program the colour change, and
using the Pulse Length option you can
select the frequency required to change
the colour.
Acid dosing pump:
• The pump turns on in response to the setpoint that was configured in the menu entitled
Measurements - Setpoints - acid pH (setpoint < pH value of the water).
• In the standard menu, the maximum dosing time is 60 minutes to avoid acidification of the water (AL3).
• It can dose either acid or alkali (please contact your supplier).
KLX
8.2
8.3 Automatic Mode: Sets the ON/OFF
times for the lights. The timers can be
configured with the following frequencies:
daily; every 2 days; every 3 days; every
4 days; every 5 days; weekly; every 2
weeks; every 3 weeks; every 4 weeks.
8.5
- Halogen spotlight.
- Spotlights with a
power consumption
greater than 50 W.
8.3
Do not connect:
Rev. B