Hepa Filter Replacement - Comfort Glow CDE4800 Instrucciones De Instalación Y El Manual De Propietario

TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair advice:
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the main power switch (in the back) is working.
3. Check to see if the battery on the remote is placed correctly, undamaged.
NOTE: For the heater to function properly, the desired temperature on the heater must be set a few
degrees higher than the temperature in the room. If the seems to not be heating, increase the desired
temperature on the heater to engage the heat elements.

HEPA FILTER REPLACEMENT

1.Remove 2 bracket screws, push up and remove the air filter.
2.Take off the HEPA filter in air filter.
3.Insert new HEPA filter and put air filter back to unit, tighten the 2 screws.
Remove bracket screws (2X)
Remove Air filter
Air inlet hood
HEPA
11