Maintenance Schedule - Nilfisk MX 107 C Instrucciones De Uso

MAINTENANCE SCHEDULE

CLEAN ALL FILTERS
CHECK POWER CORD
FLUSH OUT with DESCALER
REPLACE VAC MOTOR BRUSHES
TROUBLESHOOTING:
IF THIS OCCURS
NO SPRAY
PUMP DOES NOT RUN
LOW SUCTION
NO SUCTION
If you are unable to diagnose the problem, contact the company from whom you purchased your MX 107C
SPECIFICATIONS:
MX 107 C
EXTRACTOR
220 - 240V
CHECK THIS
Solution tank is empty.
Clogged spray tip.
Pump not running.
Valve on wand not operating
No power to pump. Test the switch. Test the pump motor. Replace if necessary.
Debris plugging cleaning tool or vacuum hose.
Drain gate is not completely closed, or seals are damaged. Vacuum lid is not closed
or gasket is damaged.
No power to motor. Test the switch. Test the vacuum motor.
Wrong tool being used.
Rotomolded Body:
Vacuum:
VAC Shutoff:
Pump:
Vacuum:
Weight:
Dimensions:
X
X
X
ALWAYS UNPLUG THE MACHINE BEFORE
DISCONNECTING OR CONNECTING ANY
WIRES OR COMPONENTS
Lifetime Warranty
3-stage
Ball float
7 Bar / 100 psi, demand pump,
28 KPA
27.1 Kg
73 X 45.7 X 67.3 cm
Around 1500 hours
.
6 0 0 1 0 1 0 7 1 R E V A