Troubleshooting - HoMedics RADIANCE MDA-100 Manual De Instrucciones E Información Sobre La Garantia

T R O U B L E S H O O T I N G
PROBLEM POSSIBLE CAUSE
Unit will not operate • Unit is not charged
Unit seems to be losing • Unit is not fully charged
suction
• Black wool filter needs to
be replaced.
• Diamond tip is not securely
installed
Diamond tip no longer • The Diamond Tip has an
seems rough
accumulation of skin cells.
F A Q
H O W O F T E N S H O U L D I U S E T H E P R O D U C T ?
It's best to start slowly – usually just once a week, then build up to 2 or 3 times a week if this is
comfortable for your skin.
W I L L I T H U R T ?
No. Treatment should not be painful. Depending on the sensitivity of your skin, you may feel slight
discomfort from the diamond tip as it moves across the skin. There could be some short-term
redness or sensitivity after treatment, but this will soon subside. If treatment is uncomfortable, you
may need to use a lower power setting or switch to the sensitive diamond tip.
C A N I U S E T H E P R O D U C T I N C O M B I N A T I O N
W I T H A N T I - A G I N G C R E A M S / S E R U M S ?
If your anti-aging cream or serum contains AHA (or acid) then it should not be used on the same
day as the microdermabrasion treatment, but can be used on non-treatment days. Non-AHA (acid
free) anti-aging products can be used at any time.
10
SOLUTION
• Charge the unit, placing firmly into
the charging base.
• Press and hold the POWER
BUTTON for 2 seconds to turn the
power on.
• Check circuits, fuses, try a different
outlet.
• Charge the unit, placing firmly into
the charging base.
• Replace the filter.
• Make sure the Diamond Tip is
secured tightly to the unit
• Clean the debris from the Diamond
tip using the included brush.
• Deep clean the Diamond Tips in
an ultrasonic cleaner (i.e., a jewelry
cleaner) to remove excess skin cell
buildup.
F C C S T A T E M E N T
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receive is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This class B digital device complies with Canadian CAN ICES-3 (B) /NMB-3 (B).
11