30-TEV3L
PACKAGING
After unpacking the appliance, check for transport damage and completeness!
⚫
Do not discard the original box! It can be used for storage and dispatch in order to avoid transport
⚫
damage.
Dispose of the packing material in a proper manner. Plastic bags should be kept away from children.
⚫
DESCRIPTION OF THE APPLIANCE
1.
Halogen lamp
2.
Grill cover
3.
Heat-insulated handle
4.
Screw, gasket and wing nut
5.
Adjustment knob
6.
Fixing knob
7.
Parasol post clamp
8.
Light holder
SETTING UP AND OPERATION
1. Rotate off the wing nut and handle; use a screwdriver to loosen the screw and gasket, then open the grill
cover.
2. Take the halogen lamp out of the packaging and place it in the light holder fitted with a spring. Ensure that
it is connected horizontally and the two ends of the halogen lamp make firm contact with the light holder.
3. Screw back the grill cover. Make sure the screw, gasket, wing nut and heat-insulated handle are in their
positions and the grill cover is correctly fixed. The heat-insulated handle should stay far away from the
light housing and grill cover in order not to be too hot when the appliance is working.
4. Make the same assembly to the other two lights.
Caution! Never use the appliance without the protective grill cover.
5. Check and make sure the parasol is undamaged and firm in a correctly fitting and sufficiently heavy parasol
base. The base must be standing on a solid, flat and horizontal surface.
6. Choose a position on the parasol post to fit the appliance. Do this at a height such that sufficient space is
heated: the higher the position; the larger the circle of radiated heat. However, do not fit the heater
between the ribs and the top of the parasol!
7. When fastening, ensure that the lights are not pointing towards a flammable surface, and the lights are at
least 2 metres above the ground and that the back of lights remain at least 30 cm away from the parasol
fabric. Flammable objects must be kept at least one metre away from the lights.
- 31 -
EN