Audemat Rds Encoder Quick Start Notice; Starting The Unit - Worldcast Systems AUDEMAT RDS Guía Rápida

English version
AUDEMAT RDS ENCODER
Quick start notice
Before you start
Make sure the following accessories are included in the box:
• 1 power cable
• 1 Ethernet cable
• 1 USB cable
• 1 folder including a quick start notice.

1. Starting the unit

Connect the power cord to the rear panel. The unit turns on automatically.
µSD card
Ethernet port
You may also connect your inputs/outputs according to your needs.
2. Using the front panel application
The key pad on the right of the screen allows you to browse through the menus:
If the screen is in standby mode, touch any key to reactivate it.
Arrows are used for scrolling
through menus, selecting
parameters and adjusting values.
LEDs indicate possible directions,
for instance, only up and down
arrows are available when
scrolling through main menus.
When adjusting values, press on
the top or down button for small
increments or swipe your fingers
around for large increments
4
RS232 ports RF input (option)
GPIO
OLED screen
MPX over AES
Analog MPX
Input/Outputs
Navigation pad
Power inlet
Input/Outputs
Ground
Status indicators
USB port
The Check button is used to:
• Access a lower level menu
• Enable the edit mode for
parameters that can be
modified,
• Confirm a new value.
The Return button is used
to
• Return to the higher level
screen,
• When in edit mode, go
back to the initial value.