Beper P101PIA001 Manual Del Usuario página 8

Electric Hotplate Use instructions
When using the unit for the first time
Without placing anything on the unit set the control for plate for about 10 minutes at maximum heat.
In this fashion the coating of the heating plate achieve its optimum protective effect. For a brief mo-
ment the unit may emanate a slight smoke. Do not be alarmed as this is normal.
Operating Instructions
This device is equipped with a thermostat. It permits an infinite variable heat control as well as
protection against overheating. Whenever the desired temperature is reached the control light will
go off. In this way the light indicates the continuous operation of the thermostat controlled heat
regulation.
Only use pots and frying pans of the correct diameter and of the type for electric heating plate. Pans
with an uneven base only waste electric energy.
Avoid placing wet lids or pots on the cast iron heating plate as this may cause it to rust.
Security Notice
Our electric appliances satisfy the relevant security regulations. Should any damage occur to the
unit or Silicon rubber wire or the power cable then retract the power plug at once. Repairs should
only be done by either our own factory customer service or an appropriately authorized repair shop.
Improper repairs may expose the user to considerable risks.
A periodically maintenance(description see in this manual) of the appliance is necessary.
The temperature of accessible surface may get hot when the appliance is operating.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The meaning of crossed-out wheeled bin symbol(e.g. This symbol indicating separate collection for
electrical and electronic equipment.)
Care of the products
The casing may be cleaned using a soft sponge and some detergent. For cleaning the cast iron
heating plate use an appropriate, specialized product. Do not use scouring agents.
Technical data
Power: 300W
Power supply: 220-240 V – 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
8