REDCAT WP-8BL150-RTR Guia De Inicio Rapido página 15

ESC GUIDE
ESC
RCR-2CENR RADIO SYSTEM
FEATURES:
Completely water-proof and dust-proof.
(Remove the cooling fan when running car in wet conditions. If the ESC gets wet, clean and dry thoroughly to avoid damage from the
oxidation of copper connectors).
External Programming Port (EPP), easily connect to a program card, and also works as power port for cooling fan.
Excellent start-up, acceleration and linearity features.
The built-in switching mode BEC is powerful enough to supply all electronic equipment with a reliable power source.
There is a mounting stand for installing the ESC on chassis easily and firmly.
Proportional ABS brake function with 5 steps of maximum brake force adjustment and 8 steps of drag-brake force adjustment. Also
compatible with the mechanical disc-brake system.
Multiple protection features: Low voltage cut-off protection / Over-heat protection / Throttle signal loss protection / Motor blocked
protection.
WARNING:
To avoid short circuits, ensure that all wires & connections are well insulated and there is proper contact at all connections. Read through
the entire manual before operating and ensure all electronics are installed correctly. To avoid accidents, we recommend setting the
vehicle on a stand, with the tires free from any contact, while connecting and adjusting electronics. Stop usage and unplug the battery
immediately if the ESC exceeds 90ºC/194ºF as this may damage both the ESC and motor.
Disconnect the battery after use. The ESC continuously draws current from the battery (even if the ESC is turned off). If left plugged in
for long periods of time, the battery will completely discharge, which may result in damage to the battery or ESC. This WILL NOT be
covered under warranty.
Specs:
Model: WP-8BL150-RTR
Cont./Peak Current: 150A/950A
LIPO/NiMH Cells: 8-18 Cells NiMH， 3-6S LiPo
Applications: 1/8 Touring Car, Truggy, Buggy, Monster Truck
Built in BEC: 6V/5A, Switch mode
Size / Weight: 59.5(L) × 48(W) × 42(H) / 178g
Programming Port: FAN / PRG Port
Motor Type: Sensored / Sensorless Brushless Motor (only in sensorless mode)
4S LiPo ： 4274 size motor， KV≤3000
Motor Limit:
6S LiPo ： 4274 size motor， KV≤2400
Resistance: 0.00035 ohm
NOTE: The cooling fans of ESC is supplied by the built-in BEC, so it is always working under 6V .
TM
14