Manufacturer's Warranty - T-Fal THERMOVISION Manual De Instrucciones

MANUFACTURER's WARRANTY

With a strong commitment to the environment, most of T-fal products are
repairable during and after the warranty period. Before returning any
defective products to the point of purchase, please call T-fal consumer
service directly at the phone number below for repair options. Your help to
The Warranty
This product is guaranteed by T-fal for 1 year against any manufacturing
defect in materials or workmanship, starting from the initial date of purchase.
The manufacturer's warranty by T-fal is an extra benefit which does not affect
consumer's Statutory Rights.
The T-fal warranty covers all costs related to restoring the proven defective
product so that it conforms to its original specifications, through the repair or
replacement of any defective part and the necessary labor. At T-fal's
choice, a replacement product may be provided instead of repairing a
defective product.
T-fal's sole obligation and your exclusive resolution under this warranty are
limited to such repair or replacement.
Conditions & Exclusions
The T-fal warranty only applies within USA, Canada & Mexico, and is valid only
on presentation of a proof of purchase. The product can be taken directly in
person to an authorized service centre or must be adequately packaged and
returned, by recorded delivery (or equivalent method of postage), to a T-fal
authorized service centre. Full address details for each country's authorized
service centre are listed on the T-fal website (www.tefal.com) or by calling the
appropriate telephone number listed below to request the appropriate postal
address.
T-fal shall not be obligated to repair or replace any product which is not
accompanied by a valid proof of purchase.
This warranty will not cover any damage which could occur as a result of
misuse, negligence, failure to follow T-fal instructions, use on current or voltage
other than as stamped on the product, or a modification or unauthorized
repair of the product. It also does not cover normal tear and wear,
maintenance or replacement of consumable parts, and the following:
- using the wrong type of water or consumable
- scaling (any de-scaling must be carried out according to the
instructions for use);
- damage due to water dust, and insects entering the product,
- mechanical damages, overloading
- damages or bad results due to wrong voltage or frequency
12
: www.t-fal.ca
sustain the environment is appreciated!