Installing And Removing The Battery Pack - Craftsman CMCCSL621 Manual De Instructiones

English
6. Place the saw chain 13 around the front of the chain
bar and engage in the nose sprocket of the chain bar.
Make sure chain is installed properly, with the cutting
teeth facing forward.
7. Pull the chain bar and chain back, engaging it in the
groove in the chain bar and then over the sprocket
positioning teeth in the correct position on the sprocket.
8. Replace the chain access cover
10 tightening securely.
Fig. F
15 13
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: Never operate a chain saw that is
damaged or improperly adjusted or that is not
completely and securely assembled. Be sure that the
saw chain stops moving when the power control
system triggers are released. Never adjust the guide
bar or saw chain when the engine is operating.

WARNING: Let the tool work at its own pace. Do
not overload.

Installing and Removing the Battery Pack

(Fig. G)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 6
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 16 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
10
15
12 and retention bolts
15 13
into the tool handle, align the
16
Fig. G
Usage (Fig. A, B)
1. Carry out regular cleaning of the unit as described in the
Maintenance section and in particular cleaning inside
the chain access cover.
2. The lower guard jaw 2 and top chain cover jaw
designed to close when one of the handles is released
or when the piece of branch being cut has been cut.
If this does not occur, discontinue use of the tool and
remove the battery pack. Check if any debris is blocking
movement. To help in this process it may be necessary
to remove chain access cover
problem is still present take the unit to a service center.
Proper Hand Position (Fig. H)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
A chain saw is intended for two-handed use. Serious injury
to the operator, helpers, and/or bystanders can result from
one-handed operation.
Fig. H
Oiling (Fig. I)

WARNING: A high quality bar and chain oil or SAE30
weight motor oil should be used for chain and bar
lubrication. The use of a vegetable based bar and
chain oil is recommended when pruning trees. Never
use waste oil or very thick oil. These may damage your
chain saw.
6
1 are
. If on assembly the
12