Health Zenith SL-5502 Manual Del Usuario

Compact Twin 150 Watt Halogen
The Heath /Zenith Compact Twin Halogen disperses light over a wide area. It includes two 150W halogen lamps, mounting plate
®
for standard junction box and is for use with 120VAC.
FOR PROPER INSTALLATION AND OPERATION, PLEASE READ THESE INSTRUCTIONS CAREFULLY.
• Allow fixture to cool before touching. The bulb and the fixture operate at high temperatures.
• Keep fixture at least 2" (51 mm) from combustible materials. Do not aim at objects closer than 3 feet (1 m).
• Use up to 150 watt lamp maximum per lampholder.
Fixture Installation Instructions
To avoid Electrical Shock:
WARNING: Turn power off at the circuit breaker or
fuse.
• Grounding and installations must comply with local codes and
the National Electric Code (Canadian Electrical Code).
• This product should be mounted on a grounded junction box and
must be used with a threaded cover plate.
• Permanently mount the fixture to a building or pole. This fixture
is for outdoor use and is wall and eave mountable.
Connect all white
wires together
Cover Plate
Wiring Fixture
1. Connect the lamp wires to the power source wiring. Secure with
wire connectors.
2. Attach the cover plate to the junction
box (Apply silicon caulk between
cover plate and junction box for
a raintight seal). Keep the fixture
horizontal (within +/- 4°) so the bulb
inside is horizontal. If the bulb is not horizontal, the bulb may
darken or shatter and fail prematurely.
595-5573-07 © 2010 HeathCo LLC
Model SL-5502
To Avoid Fire or Burn Hazards:
Junction box ground
wire to green ground
screw on fixture
Connect all black
wires together
No Service Parts Available for this Product
3. Loosen the side bolt connected to the arm to aim the fixture up
and down.
4. For a rain tight seal, caulk the aiming arm joint with silicon
caulking compound.
Bulb Installation and Replacement
CAUTION: When replacing bulbs, turn power off and
let the fixture cool.
Important: Use a clean glove or cloth when handling the
new bulb. Use isopropyl (rubbing) alcohol to clean the bulb
if it is touched with your bare hands.
NOTE: Bulbs are included, but need to be installed. The bulbs
are located behind the glass cover of each lamp head.
1. Open lamp head with a phillips head screwdriver. To remove the
old bulb, push the bulb towards the right until the left side of the
bulb is clear of the left socket.
2. To install the bulb, place one end of the bulb on the contact in
the right socket. While pushing the bulb against the right con-
tact, lower the other end of the bulb onto the contact in the left
socket.
3. Spin the bulb to verify it is seated properly.
4. Close the lamp head and tighten locking screw securely.
+/- 4°
Left Socket
Contact
Bulb Lamp Head
1
2
Right Socket
Glass Cover
595-5573-07