Audiolab EDGE 15sub Manual Del Usario página 7

4. SYSTEM CONNECTION PLATE
Make your initial connections with all the equip-
ment powered off, and ensure that all the main
volume controls are turned completely down.
Two Active Subwoofers & Two Passive
Satellite Speakers
1) Connect one side of the signal cable to the
output of your mixer (left / right) with a TRS or
XLR connector and the other side of the cable to
the line input (combo) in the active subwoofer
(with a TRS to XLR connector). Then connect the
speakon cable from the output of power in the
Line
Input
Subwoofer
Satellite
IP Control
PC with WiFi
Pole
Wireless Router
Main Out Left
Line in
Left/Mono
Subwoofer to the satellites input.
2) Complete other connections as illustrated.
3) Turn on your mixer first, then the stereo pow-
er amplifier.
4) Turn up the volume controls of your amplifier
to about 70%.
5) Use PFL function to get the proper input level
for the mixer, and adjust the Mian Mix Level con-
trol to manipulate the output level.
6) After using, turn off your stereo power ampli-
fier first, then the mixer.
Satellite
Pole
Main Out Right
Line in
Right/Mono
Subwoofer
Mixer
Line
Input
- AUDIOLAB EDGE 15 sub
English version
P. 7