ASROCK AD525PV Manual Del Usuario página 10

2.3 Installation of Memory Modules (DIMM) 2.3 Installation of Memory Modules (DIMM) 2.3 Installation of Memory Modules (DIMM) 2.3 Installation of Memory Modules (DIMM) 2.3 Installation of Memory Modules (DIMM)
AD525PV / AD425PV motherboard provides two 240-pin DDR2 (Double Data Rate
2) DIMM slots.
It is not allowed to install a DDR memory module into DDR2 slot;otherwise,
this motherboard and DIMM may be damaged.
Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
Step 1. Unlock a DIMM slot by pressing the retaining clips outward.
Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
The DIMM only fits in one correct orientation. It will cause permanent
damage to the motherboard and the DIMM if you force the DIMM into the
slot at incorrect orientation.
Step 3. Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.
1 0 1 0 1 0
1 0 1 0
ASRock AD525PV / AD425PV Motherboard