Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Apply plumbers
putty here.
1. Install the Duostrainer
All information in these instructions is based upon the latest product
information available at the time of publication. Kallista reserves the
right to make changes in product characteristics at any time without
notice.
Apply a ring of plumbers putty or other sealant to the underside
of the edge of the drain body according to the manufacturer's
instructions.
Insert the drain body in the sink.
Partially thread the screws into the mounting nut until they
protrude slightly through the mounting nut. From under the sink,
slide the rubber washer and steel washer on the drain body, and
then thread the mounting nut onto the drain body until it is
about 1/4" (6 mm) from the sink bottom.
Tighten the three mounting screws to draw the body tight against
the basin of the sink.
NOTE: Do not reposition the drain body after it has been tightened.
Kallista
Cup
Drain Body
Rubber Washer
Steel Washer
Mounting Nut
Screws
Small Gasket
Tailpiece
Nut
3
1035389-2-B
Publicidad
Tabla de contenido
