Operating Instructions; Quick Start Procedure; Specifications - General SEEKER 312 Manual Del Usuario

OPERATING INSTRUCTIONS

QUICK START PROCEDURE

1. Press and hold the
scope and illuminate the LCD.
2. Press the
3. Press the
4. Press the
again to undo the inversion.
5. Press the
button enlarges the frame 20%, corresponding to a zoom level of 1.2X.
"X 1.2" will appear in yellow at the bottom right of the screen. Push the
button again to zoom in closer at a level of 1.4X, 1.6X, 1.7X, 1.8X,
1.9X or 2.0X. The next push of the
(1X) viewing.
Because the probe is flexible-obedient, you can maneuver it into various positions
to aim at different targets and it will hold its shape. To protect the camera-tipped
end of the probe, reinstall the black rubber lens cap after each inspection session.
The DCS312 is designed to be powered for several hours by the same set of four
"AA" batteries. To replace the batteries, follow the procedure on p. 5 of this manual.

SPECIFICATIONS

Display Size/Type
Display Resolution
Monitor Controls
Probe Diameter & Type
Probe Length
Probe Field of View
Probe Depth of Field
Camera Light Source
Impact Resistance
Water, Dust, Oil Resistance Levels
Video Out Format/Cable Length
Battery Life
button for at least 3 seconds to power on the
button to increase the brightness of the camera's LEDs
button to decrease LED brightness
button to flip the video (rotate it 180°). Press the button
button to enlarge the video frame. The first press of the
button reverts to normal size
3.5 in. (89mm) diagonal TFT color LCD
320 x 240 pixels
180° flip, 1X to 2X zoom in 7 steps,
brightness + and –
12mm (0.47 in.) flexible-obedient
1m (39 in.)
60°
4 in. to 8 ft. (102 mm to 2.4m)
4 adjustable-brightness white LEDs
To height of 1m (39 in.)
Camera-tipped probe: IP67
Grip and monitor: monitor: IP54
NTSC/3.94 ft. (1.2m)
>3 hours (typical)
7