Remote Control Installation - Dimplex 7206620100R02 Manual De Instrucciones

INSTALLATION
MANUAL CONTROL
FIGURE 4
FIGURE 5
MANUAL CONTROL
FIGURE 6
MANUAL CONTROL REMOVAL
1. Open steel curtain (remove glass doors if
applicable).
2. Remove two screws on log grate and
remove log grate (FIGURE 4).
3. Pull front edge of plastic ember bed grate up
and forward until rear tab releases from the
ledge located at the bottom of the mirror.
(FIGURE 5)
Note: Log set fits tightly into firebox, some
force may be necessary to remove.
(FIGURE 5)
4. Locate and remove the two screws on the
manual control bracket. Remove the
bracket. (FIGURE 6)
5. Locate and depress the mounting tabs on
the plug connector and remove the manual
control bracket. (FIGURE 6)

REMOTE CONTROL INSTALLATION

1. Locate and insert the plug connector on the
2. Locate and install the two screws on the
3. Replace the log by inserting front edge and
4. Replace log grate using two screws
DEPRESS MOUNTING
TABS
PLUG CONNECTOR
remote control bracket into plug connector
on the fireplace. FIGURE 7)
remote control bracket.
pushing the back down until rear tab snaps
under back ledge (FIGURE 5) and the logs
are resting against mirror.
previously removed.
REMOTE CONTROL
FIGURE 7
PLUG CONNECTOR