Fold Test; Remote Control; Before Initial Use; Installing The Batteries - Sunbeam Bedding Manual De Usuario

Fold test

CAUTION: Do not continue the fold test for more than seven minutes. DO NOT attempt to make any internal adjustments to this appliance. If you have followed each step of the fold test and the
warming product does not heat, stop using it immediately, disconnect the power cord and contact Consumer Services at the 800 number listed under How to Obtain Warranty Service (page 11).

Installing the Batteries:

Before initial use:

1 Remove product from vinyl storage bag /box.
2 Pull controls from center fold of the warming product.
3 Make sure the base unit cord is connected to the
blanket/mattress pad module then plug the power cord
into an outlet.
1 Remove the battery compartment door from the back of the
1

remote control.

2 Insert three AAA batteries, matching the + and - markings in
2
the battery compartment to the markings on the batteries.
3
3 Replace the battery compartment door.
4 If your blanket/mattress pad has two remote controls, repeat
steps 1 – 3 to install batteries in the second remote control.
(Three AAA batteries per control not included)
4 Press "On/Off" button, then turn the control to the
highest setting and wait five to seven minutes.
5 Put your hand between the folds and you should feel the
blanket /mattress pad warming. Note: Remember, the
warming product is not a heating pad. It will not feel
hot to the touch when laid out flat in a normal manner.
3