Operation - Blumfeldt Andora Flame Manual Del Usuario

EN
24

OPERATION

Ignition
To light heater
Fit battery type AAA provided into ignition button ("+" side up). Remove
battery during periods of non-use to prevent battery leak.
1. Turn on the gas by turning the gas regulator to the on position.
2. Press down and turn the control knob to Pos.1 and hold for 10 seconds.
3. Whilst still pressing down the control knob press the ignition button until
the pilot light (at the bottom of the burner) ignites.
4. Continue to hold the control knob down for 10-15 seconds more, release
the button, then it is the maximum heat setting.
5. If the pilot flame goes out repeat the above operation.
The above temperature range is just for refence,not exact.
The heater will turn off in case the door is opened during working.In case the
heater turn off during working,YOU MUST WAIT 5 minutes before trying to
turn on the stove again.
Heat settings
Change from Pilot to Minimum position 2 gently by press control button,turn
control knob to position HIGH for maximum, gently press control button and
turn it to position 1 will be only pilot setting.
LOW
HIGH