MYDLINK DCS-8600LH Guia De Inicio Rapido página 9

Power Supply Mounting instructions
6. Place the baseplate at the desired location,
assuring that it is placed where close enough
for the cord to reach a power outlet. Make
sure the release tab facing up. Use a pencil to
mark the holes.
7. Using a 6 mm drill bit, drill two 25 mm deep
holes over the pencil marks. For a plaster,
drywall, or concrete wall, insert the plastic
anchors to support the screws first.
8. Place the baseplate over the holes. Use the
supplied screws to attach the baseplate to
the wall.
9. Align the power supply with the baseplate.
Press towards the wall to snap into place.
10. Connect the USB cable from the camera to
the power supply. Plug the power supply
into the power outlet.
Note: Both power cords can be used both
indoors and out.
DCS-8600LH
1
2
3
4
5
6
7
2
8
9
10
10
9