Publicidad
Idiomas disponibles
Idiomas disponibles
JUNO NEW CONSTRUCTION RECESSED JUNCTION BOX HOUSING
.
ELECTRICAL CONNECTION
INSTRUCTIONS
Figure 9
Step 1. Provide electrical service according
to national and/or local electrical code to
the junction box. Supply wire insulation
must be rated for at least 90°C.
Step 2. Remove wiring box cover. Remove
the appropriate knock-out(s) to
accommodate the type of electrical service
to be used/allowed by your local electrical
code (Figure 9)
Metal Conduit. Remove appropriate round
knock-out(s) and connect conduit to wiring
box with proper connectors (not supplied).
12/2 or 14/2 Non-Metallic Sheathed Cable
(Type NM-B). Remove appropriate D-
shaped cable knock-out(s). Insert NM-B
cable through cable trap and make a 90˚L-
shaped bend in cable as shown. (Fig 10)
12/3 or 14/3 Cable (Type NM-B). Remove
appropriate round knockouts and connect
cable with proper electrical connectors (not
supplied and not shown)
Step 3. Strip supply wire 3/8'' and insert
each supply wire into appropriate
connector. Connect black fixture wire to hot,
white fixture wire to neutral and green
fixture wire to ground.
Connect violet (+) and gray (-) dimmer
wires, if utilizing 0-10V dimmer.
Step 4. Place all wiring and connectors
back in wiring box and replace cover.
Figure 10
FIXTURE DIMMING
Universal Voltage (MVOLT) Downlights:
Universal input voltage (120VAC thru
277VAC) housings. Dimmable with use of
most 0-10V wall box dimmers.
120VAC (120) Downlights: 120VAC input
voltage housings. Dimmable with the use
of most incandescent, magnetic low
voltage or electronic low voltage* wall box
dimmers.
Consult Juno Product Services or website
for compatibility.
*Electronic low voltage dimmers require a
neutral wire connection in the wall box
DRIVER REPLACEMENT
Driver replacement must be performed by a
qualified electrician. Replacement kits can
be ordered to match your specific fixture
type. The replacement kits include detailed
instruction for driver replacement. Remove
junction box from fixture to access driver.
TRIM INSTALLATION
IMPORTANT:
must be turned off prior to installing these
LED trims. Failure to do so can cause
electric shock, which can result in injury or
.
death
Step 1. After ceiling is finished and painted,
remove and discard paint shield from
fixture.
Step 2. Take trim mounting bracket and
secure it as shown in (Fig. 11 & 12) with
provided flat head screws to junction box.
Step 3. Place provided trim ring around
LED trim. Plug the connector provided on
the LED trim into the mating connector in
the junction box housing by pushing firmly
1300 S. Wolf Road • Des Plaines, IL 60018 • 800-323-5068 • www.acuitybrands.com
©2017 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
Power to the junction box
Figure 11
Rev 0419
P4716
IC1JBPF Series
to ensure connectors are securely fastened.
Insert trim into housing using push in friction
springs.
Note: Trim must be oriented so that center of
friction springs aligns with the orientation
indicator notches on the mounting bracket (see
Fig. 11). Carefully push trim towards ceiling
until fully installed with trim ring flush to the
ceiling.
Figure 12
Step 4. Turn power on to fixture
Warranty
5-year limited warranty. Complete warranty
terms located at
www.acuitybrands.com/CustomerResources/Te
rms_and_conditions.aspx
Technical Services Phone (888) 387-2212
2 of 2
Publicidad
