LSI RHB Serie Manual De Instrucciones

IMPORTANT: READ BEFORE REMOVING FIXTURE FROM CARTON. RETAIN FOR FUTURE REFERENCE
SAFETY: This fixture must be wired in accordance with the NATIONAL ELECTRICAL CODE and applicable local codes and ordinances.
A person familiar with the construction and operation of the product and the hazards involved must install this product. A qualified
licensed electrician should complete all work. Proper grounding is required for safety.
WARNING: Make certain power is OFF before installing or maintaining fixture.
RISK OF INJURY: Fixture may become damaged and/or unstable if not installed properly.
Step 1: Eye Bolt Suspension
1. Install the enclosed eye bolt hook into the top of the luminaire
housing, and tighten securely. Tighten the lock-nut to prevent
the eyebolt from loosening.
2. Suspend fixture with chain or cable securely attached to fixture
eye bolt.
Step 2: Wiring
1. Turn off electrical supply at the breaker.
2. Pull building supply leads into the housing through the access plate.
3. Follow all local electrical codes for wiring and grounding requirements.
4. Grip black supply wire firmly and push into connector port marked
with black circle (opposite black driver wire).
5. Grip white supply wire firmly and push into the remaining port.
6. Use only conductor per port and assure that no copper is exposed
on any of the wires inserted.
7. Turn on electrical supply at the breaker.
Reflector/Refractor Installation Instructions
1. Loosen reflector/refractor screws on the face of the fixture to allow the reflector/refractor key hole slots to be placed onto screws.
2. Place reflector on the fixture face. Rotate the reflector slightly, clock-wise, to engage screws into keyhole slot area.
3. Tighten screws to secure reflector to fixture housing.
RHB Series
Model:
LED Round High Bay
Wiring Diagram
BLACK
LINE
NEUTRAL
WHITE
GREEN
GROUND
eye bolt
LED Driver
240-RHB