Cleaning And Maintenance - IRIS IC-FDC1U Serie Manual De Instrucciones

HOW TO USE
Cleaning Bedding
1 Please spread out the bedding or mattress pad to lay flat
(no folds) .
2 Adjust the vacuum to the horizontal position .
3 When the device is in High mode, move back and forth
every 10 seconds .
Please do not forcefully press down the collection head .
Adjusted to 90°, the device will not work .
• Adjusted to the horizontal position, the collection
head is fastened in place by a magnet .
• When cleaning furniture, cushions, carpets, etc .
with the collection head in between, the head is not
locked in place and may be unstable .
Dust Sensor
Dust and dust mite sensor works during use, and light
indicates the amount of dust on the surface area .
*When cleaning carpets or other items with high dust levels,
indicator light will not turn green .
Bedding Sensor
Device will conserve power and decrease speed when both
sensors lose contact with the object being cleaned .
Magnet
Dust Indicator light
Dust Indicator light
RED
Not clean
YELLOW Almost clean
GREEN
Clean
Bedding sensors
7

CLEANING AND MAINTENANCE

Cleaning and maintenance must be done after removing the battery .
Please do not splash water on the vacuum body as this could cause damage .
CAUTION
Use a diluted neutral cleaning agent .
Use of strong cleaning agents such as amyl acetic ester, alcohol, oil, etc . can cause fading,
deformation or breakdown .
Using the product in dusty condition can cause it to malfunction . Check and clean the product regularly .
Vacuum Body
Fully wring out a rag and use it to wipe down the body and any
remaining cleaner .
Battery
Please use a dry rag on the terminal parts of the battery to clear
out accumulated dirt which can disrupt product use .
• Incorrect assembly of the mesh filter and dust cup can
allow dust and dirt inside which can damage the terminals .
Dust Indicator Sensors
Remove the dust cup and clean both sides of the sensors with a
cotton swab .
• Please clean regularly to avoid dust buildup, causing sensor
to function poorly .
Collection Head
• Clean hair, string and other small objects from the dust
intake port using tweezers to prevent dust buildup and
decreased suction . Please clean it regularly .
• Please clean dirt on the agitator with a brush .
• Please clean bedding sensors with a cotton swab .
• Clean regularly to prevent dust buildup causing sensors to
function poorly .
Dust sensors
Agitator
Bedding sensor
8
Terminal