Technical Data; Vibration Information - Worx WG441E Manual Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
METAL / HARD NYLON JOINT CLEANING BRUSH
18.
(WA0293)
19.
JOINT ALIGNMENT MARK
* Not all the accessories illustrated or described
are included in standard delivery.

TECHNICAL DATA

Type Designation WG441E WG441E.9 (441-
designation of machinery, representative of
Battery-operated brush)
WG441E
Rated voltage
Max. No-load
speed
Water pressure
Rotational speed
Machine weight
3.7 kg
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
ACCESSORIES
Battery pack
Charger
Soft nylon bristles-wood,
delicate and easily marked
surfaces like artificial turf
Hard nylon bristles -
General stone and hard
surfaces like brick, paving
stones, marble floor and
natural stone
Hard nylon joint
cleaning brush-Mortar
joint cleaning for finished
stone surfaces
Metal / hard nylon joint
cleaning brush -Mortar
and sand joint cleaning for
bricks and block paving
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
Patio-Brush
WG441E.9
20 V
Max.**
700 /min
0.6 MPa
H:700 /min; L:500 /min
2.9 kg
Code
WG441E WG441E.9
WA3014
1
WA3880
1
WA0290
/
WA0291
1
WA0292
/
WA0293
1
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
K
wA

VIBRATION INFORMATION

Vibration emission value
Uncertainty
OPERATION INSTRUCTIONS
NOTE: Read instruction handbook before
operation this machine.
INTENDED USE
The device is intended as a handhold cleaning and
maintenance device.
ASSEMBLY AND OPERATION
/
BEFORE OPERATION
/
Checking the battery charge condition
NOTE: Fig. A1 only applies for the battery
/
pack with battery indicator light.
Charging the battery pack
More details can be found in charger's
manual
1
Installing the battery pack
Removing the battery pack
ASSEMBLY
/
Assembling the shaft
Assembling the auxiliary handle
1
Replacing the brush
NOTE: Choose a suitable brush according
to your work. See more details in the
ACCESSORIES section.
L
L
wA
ACTION
= 65.2 dB(A)
pA
3.0 dB(A)
= 78.61 dB(A)
3.0 dB(A)
a
< 2.5 m/s
2
h
K = 1.5 m/s²
11
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig. B
See Fig. C
See Fig.
D1-D4
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wg441e.9

Tabla de contenido