Clean the air quality sensor:
•
The air quality sensor of the air purifier should be cleaned at least every
•
2 months to ensure accurate measurement.
First, remove the air quality sensor cover and clean it and the air
•
vents above and below with a soft brush or cloth.
Now carefully clean the air quality sensor with a cotton swab. See the
•
illust-ration on the sticker next to the air quality sensor on the unit.
Finally, replace the cover of the air quality sensor.
•
Malfunctions and remedies
Current operating instructions can be found at http://www.comedes.com
Turn off the unit immediately and contact your dealer if any of the following problems occur:
Fuse's blown.
•
Foreign material gets into the device.
•
The plug or power cord heats up.
•
Do not open the unit without authorized service personnel. However, you can check
the following causes of faults yourself:
The device cannot be switched on:
Is the plug inserted correctly?
•
Has the fuse blown or is there no voltage at the socket?
•
Is the front cover fitted correctly?
•
The air flow at the outlet opening is lower:
Is the filter too dirty or clogged?
•
The device is disproportionately loud:
Does the device stand on an uneven surface?
•
Isn't the filter unpacked?
•
Is the filter too dirty or clogged?
•
Remote control does not work:
Replace the battery.
•
Smoke and odours are filtered very poorly.
•
Are the filters inserted in the correct order?
Aren't the filters unpacked?
•
Do the filters have to be replaced?
•
ENG-10
www.comedes.com