NuTone 605RP Manual De Instrucciones página 3

4. Use a flat-bladed
screwdriver
to remove the
proper electrical
knockouts.
Installation work and electrical wiring must be done by a quali-
fied person(s) in accordance with all applicable codes and stan-
dards, including fire-rated construction codes and standards.
5. Connect
electrical
wiring as
shown.
HEAT
A
3 WHITE
WIRES
2 RED
WIRES
RED
HEAT
VENT
BLACK
3 GROUND
WIRES
120 VAC LINE IN
C
VENT
C
A
2 GROUND
WIRES
2 BLACK
WIRES
2 WHITE
WIRES
WIRE OPENING
If the switch has not been wired properly and wires need to
be moved:
1. Each wire opening has a release slot.
2. Push a small nail or screwdriver into release slot while
gently removing wire.
3. DO NOT pull any wire out of the switch without using
the release slot. The switch may be damaged.
6. Replace the fan assembly removed in Step 4, under "PRE-
PARE THE UNIT" on Page 2. Plug fan assembly into recep-
tacle (C) on the the side of the wiring cover. Direct wires away
from blower inlets.
7. Replace the heater assembly removed in Steps 2, 3, under
"PREPARE THE UNIT" on Page 2. Plug heater assembly into
receptacle (A). Direct wires away from blower inlets.
8. Install grille and
grille bracket.
Tighten acorn
nut securely. Be
careful not to
overtighten nut.
9. Install grille
cover. Gently
squeeze tabs
on cover and
insert them
into the slots
in the grille.
MODEL 605RP
Page 3
RELEASE SLOT